强流脉冲离子束辐照靶及其喷发的数值研究

利用拟合实测的TEMP Ⅱ型加速器磁绝缘二极管(MID)电压波形及其焦点附近束流密度曲线，建立了Gaussian分布模型，据此计算了与靶作用的离子的能量及数量，采用Monte Carlo(MC)方法计算了沉积在靶内的能量.并以此作为热源，与流体动力学(HD)模型相结合，对不同的靶状态采用相应的状态方程，模拟计算了靶内压力演化情况; 同时对烧蚀产生的等离子体采用理想气体状态方程, 结合HD方程组, 模拟计算了喷发过程中压力的空间演化过程. 关键词： 强流脉冲离子束 Gaussian模型 HD方程 数值研究     

Er3+掺杂的Bi2O3-B2O3-SiO2玻璃的光谱性质

测试了Bi₂O₃-B₂O₃-SiO₂玻璃中的Er³⁺离子的吸收光谱、发射光谱、⁴I_13/2的荧光寿命、拉曼光谱,及OH^-的傅里叶红外吸收光谱。应用Judd-Ofelt理论计算了该玻璃中的Er³⁺离子的J-O参数、振子强度、⁴I_13/2能级的寿命,从而利用测得的⁴I_13/2的荧光寿命得出了⁴I_13/2能级的量子效率(15%)。由于较低量子效率可能与OH^-有关,所以计算了玻璃中的OH^-浓度,发现其浓度较高(1.66×10¹⁹cm^-1,相当于Er³⁺浓度的3倍)。应用McCumber理论和四能级模型计算了Er³⁺离子的受激发射截面和荧光发射光谱的半峰全宽,结果与通过吸收光谱计算所得基本吻合。根据透射率和折射率的关系计算了折射率,发现和测量值相差很大,说明有较大的散射,通过拉曼光谱和显微镜测试,认为是玻璃中的微小气泡造成的。     

高温超导带材交流损耗的数值计算与分析

高温超导带材在许多领域得到越来越广泛的应用。交流损耗计算对于高温超导带材具有重要意义。该文介绍了两种交流损耗的数值计算模型,并以其中一种模型为例,对带材的交流损耗进行计算,与Norris公式计算结果作了比较,证明结果有效。最后提出了交流损耗数值计算中存在的问题。     

Fundamental processes in long air gap discharges

The development of atmospheric lightning is initiated and sustained by the formation in virgin air of ‘streamer corona’ and ‘leader’ discharges, very similar to those observed in laboratory long sparks. Therefore, the experimental and theoretical investigations of these laboratory discharges have become of large interest to improve the physical knowledge of the lightning process and to develop self-consistent models that could be applied to new protection concepts.In the present paper the fundamental processes of the subsequent phases of long air gap discharges are analyzed, from the first corona inception and development to the leader channel formation and propagation. For all these processes simulations models are discussed that have been essentially derived and simplified by the authors, in order to develop sequential time-dependent simulation of the laboratory breakdown, with both positive and negative voltages. The possibility of extending these models to the case of natural lightning is discussed in the companion paper, presented in this same volume. To cite this article: I. Gallimberti et al., C. R. Physique 3 (2002) 1335–1359.     

Theory of interfacial phase transitions in surfactant systems

The spin-1 Ising model, which is equivalent to the three-component lattice gas model, is used to study wetting transitions in three-component surfactant systems consisting of an oil, water, and a nonionic surfactant. Phase equilibria, interfacial profiles, and interfacial tensions for three-phase equilibrium are determined in mean field approximation, for a wide range of temperature and interaction parameters. Surfactant interaction parameters are found to strongly influence interfacial tensions, reducing them in some cases to ultralow values. Interfacial tensions are used to determine whether the middle phase, rich in surfactant, wets or does not wet the interface between the oil-rich and water-rich phases. By varying temperature and interaction parameters, a wetting transition is located and found to be of the first order. Comparison is made with recent experimental results on wetting transitions in ternary surfactant systems.This paper is dedicated to J. K. Percus in honor of his 65th birthday.     

周期性梯度折射率多层膜的软X射线反射率

由于界面互扩散的存在，实际的超薄多层膜很难具有清晰的界面结构.假设超薄多层膜为具有周期性梯度折射率的多层膜结构，用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率.结果证明，折射率余弦渐变的多层膜虽然不具有清晰的界面，但它同样具有很高的反射率.     

基于GRIN透镜微小角位移的测量技术研究

根据1/2波节自聚焦（GRIN）透镜中光的传输特性,提出了一种新颖的测量微小角位移的模型,通过对模型中光线传输和几何关系的理论分析,推导了待测角位移与光耦合效率之间的传递函数.针对模型对测量范围的限制,提出了一种可行的拓宽测量范围的方法.研究结果表明,该模型不但测量范围宽,而且测量准确度高,线性度好.     

基于FPGA并行处理的实时图像相关速度计

研究制作了一种采用高速线阵CCD的实时相关速度计,其测量数据的输出速率可达每秒一万次。针对以往光学相关测速方法的问题进行了讨论,探讨了适合FPGA并行处理的算法,制作了高速线阵CCD摄像机及其处理装置。通过实验验证了系统的可行性和可实现性。     

A finite model property for RMImin

It is proved that the variety of relevant disjunction lattices has the finite embeddability property. It follows that Avron's relevance logic RMI _min has a strong form of the finite model property, so it has a solvable deducibility problem. This strengthens Avron's result that RMI _min is decidable. (© 2006 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Commuting and stable feedback design for switched linear systems

In the paper, commuting and stable feedback design for switched linear systems is investigated. This problem is formulated as to build up suitable state feedback controller for each subsystem such that the closed-loop systems are not only asymptotically stable but also commuting each other. A new concept, common admissible eigenvector set (CAES), is introduced to establish necessary/sufficient conditions for commuting and stable feedback controllers. For second-order systems, a necessary and sufficient condition is established. Moreover, a parametrization of the CAES is also obtained. The motivation comes from stabilization of switched linear systems which consist of a family of LTI systems and a switching law specifying the switching between them, where if all the subsystems are stable and commuting each other, then the total system is stable under arbitrary switching.